Trans Information

All LENCO transmissions operate in basically the same way and if you have any questions about servicing your trans please call our tech line at (800) 854-2944 or (619) 287-2500 in California).

INSTALLATION

(on all LENCOS)

Before you install the transmission you must measure the clearance between the pilot bearing end of the input shaft and the rear face of the pilot bearing. See (input diagram).There must be a minimum of .060" to a maximum of .090" of clearance between face of pilot bearing to beginning of clutch spline.

LENCO transmissions are shipped with the shift levers removed in order to prevent damage during shipping. To install lever remove bolt, insert lever in shift tower so that it faces forward and install bolt. When the installed lever is loose that section is in low and when the lever is tight the sections in high.