CHECKING SHIFT PRESSURE

(only on CS-1 style or center shift transmissions)

To measure the shift pressure install checking lever into tower screw jam nut all the way up the tower so it's out of the way. Now rotate tower clockwise until it lightly touches pin on shift fork then rotate tower counter clockwise 2 turns and place hook of scale in top hole of checking lever supplied with transmission (this lever should be about 5 1/2" over all length) and pull scale slowly to shift section, taking note of highest reading this is your shift pressure. If the shift pressure is set to your application lock the jam nut your finished, if not you then need to add shim to raise pressure or subtract shim to reduce pressure. If needed you may vary 1 full turn up or down from your 2 turns out in order to achieve the shift pressure desired.